Product Quality Engineer

• Early engage in part-system (PRD, ERS) study during NPI, co-work with PD/Eng/SDE to standardize & enhance the material NUDD process, establish the early alarm system by analyzing the existing data and predict the risks of future supply.
• Improve and standardize the IQC process and enhance the traceability capability from the E2E supply chain.
• Build up the lessons learned system to drive consistency:
• o Major material issues reporting, traceability, documentation & visualization, which occur/captured at Upper Stream, IQC or FATP.
• o Study & Research on spec alignment between critical Part/Module and System.
• o Coordinate a regular platform for knowledge, practice and lessons-learnt sharing between SQE & PQE teams.
• o Optimize and coordinate multiple resources (Contract Manufacturer (CM), Vendors, 3rd-parties) for Sourcing Inspection execution.
• o Vendor OQC & CM IQC optimization and alignment - including test equipment/fixture sourcing, test setup, reasonable sampling plan (AQL), vendor OSS arrangement, golden/limit samples managements, etc.
• Conduct audits at all CM sites (including IQC, IPQC, ORT and OQC etc.) to make sure the quality procedures and practices are fully aligned. Able to perform quality system & process audits per ISO 9000 requirements.
• Work with Customer Product Quality Engineer (PQE) and CM Quality Manager/Engineer to set up regular process audits, standardize the audit reporting format, and follow up with the CM teams on corrective actions (CA's) process improvements.
• Perform regular First Article Inspection (and PFOL) for engineering changes or for new part & product (new part numbers) introduction (BOM, Drawing vs actual parts).
• During NPI phase, regularly update the status of IQC bring up, qualification and correlation study, drive parts level golden & limit sample readiness, also support Customer PQE to provide training to CM IQC engineers and inspectors.
• Support Customer PQE to set up the inspection skill monitor system at CM site and audit the faulty injection test (FIT) samples and status periodically.
• Work with Customer PQE and CM supplier quality engineer to finalize the parts level measurement method and analyze the measurement data for sub-tier supplier process improvement.
• Support Customer PQE to set up traceability control system for all mechanical parts and electronic components at NPI stage.
• Audit CM quality reports to make sure the data is accurate.
• Work with Customer PQE and CM quality team to drive quality issue failure analysis (FA), review 5C/8D report and follow up with the CM/supplier quality teams on corrective actions (CA's) and preventive actions (PA's) implementation.

• BA in Electronics Engineering, Mechanical Engineering, Automation, or related fields.
• Good command of English, ability to communicate in Chinese is a plus.
• Minimum 7-8 years' experience in all levels' quality management in electronic manufacturing industry (OEM, ODM, JDM, or EMS).
• Good understanding and practical experience relating to FATP (Final Assembly, Test & Packing)
• Experience in managing outsourced manufacturing suppliers.
• Familiar with all the quality tools such as GRR / Correlation / FAI / CPK/ CTQ, etc.

SCRG